Nokia Lumia 800 Teardown – Disassemble & Reassemble – Battery & Case Replacement

Screen Change Only Screen Frame Swap Fully detailed guide that should come in handy for anyone wishing to change the case, headphone socket, speaker etc. Skip Intro: 0:27 Remove Battery 3:39 (BV-5JW 1450mAh 3.8v 5.5Wh) Same as N9 Earpiece 4:50 Hot Air Needed 5:40 Headphone Socket 9:09 Reassembly 10:42 Small Magnet 11:29 Front Microphone 13:20 Earpiece Rubber Gasket 13:56 Insert Battery 15:15 Screen on 17:33 The USB door is the same as the N9 and does ‘pull off’ but unless you have a replacement it will be floppy when you put it back on. If you turn it on before the screen is connected you will need to reset the phone by disconnecting the battery for a few seconds. I used a fan heater for the hot air to soften the glue. High Resolution Scan of the mainboard (5000×5000) 7Mb Shot with a Panasonic HDC-SD700 Scan of small circuit board **Someone asked if I could make a video on only replacing the digitizer. The AMOLED display is made of glass and is 0.45mm thick, even with my patience and experience I seriously doubt I could separate it from the digitizer without breaking it. This shows how hard it can be

Add a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.